Worldwide Shipping. Free U.S. Shipping.
Duet 3 Toolboard 1LC + Connector Pack

Duet 3 Toolboard 1LC + Connector Pack

Regular price $0.00 $72.63 Sale

Key Features:

  • Designed to make it easy to connect multiple direct driver extruders in a tool changer or other multi tool machine
  • ARM Cortex M0+ processor running at 48MHz
  • One TMC2209 stepper driver with stall detection and stealthChop
  • Outputs to connect both the 3-wire 12V hotend fan and the 4-wire 12V cooling fan
  • CAN-FD interconnect to main controller board and other Toolboards or expansion boards

The Duet 3 Toolboard is a CAN-FD connected expansion board for the Duet 3 Mainboard that is designed to provide complete control for a direct drive extruder. The mounting holes and connector locations match an e3d Hemera, however it can be used with other direct drive extruders with suitable brackets. The stepper motor, heater, temperature sensor, fans and optionally Z probe and filament monitor all connect to the Duet 3 Toolboard, leaving only CAN-FD and power wires to run back to the Duet 3 Mainboard or Tool Distribution Board.

Comes with connector pack: 3-way & 4-way JST ZH tail 150mm with plug (optional filament monitor connector or CAN in), 4-way JST PH tail 300mm with plug (motor connector), 2-way JST VH housing & crimps and white single ferrules for heater screw terminals.

Item Specifics
1 - Duet 3 Toolboard
1 - Connector Pack
Two thermistor or PT1000 inputs (Temp0 and Temp1). One (input Temp0) uses a 16-bit ADC for high resolution reading of PT1000 sensors.
One 4-pin connector (IO_0) - example use case a Z-probe with 5V power. As of RRF 3.01-RC3, only Z probe modes 8 and 9 are supported.
One 3-pin connector with 3.3V power(IO_1).
One 3-pin connector with 5V power (IO_2).
Two push buttons.
Two LEDs.
12 to 32V power input.
On-board 12V, 5V and 3.3V regulators.