Key Features:
- World's smallest 3D printer nozzle
- Individually drilled and tested
- Expert use only
- Requires geared extruder like Bondtech, Iroberti/Meduza, or UM2+
This is the World`s smallest 3D printer nozzle. They are individually drilled and checked, and extremely difficult to manufacture.
These are difficult to use. It is recommended that you can print with an 0.15 nozzle “blindfoldedly” before using this one. It prints at lower temp (190 – 205C), since the material stays long time inside. Do not change material type without “Cold Pulls” in between.
Use Cold Pull before and after every print. This cleans out the nozzle. The 0.10. has the surface area (opening size) of only about 14% of a 0.25mm hole. A 0.40mm nozzle has a 15 times higher plastic output than the 0.10mm 3D Solex Micro. This nozzle will not work with an ungeared feeder like UM2 (not “+”), or without a high tech feeder likte Bondtech. Made in Norway by hand, using a Swiss “drill” and German tools.
Item Specifics
Weight: 0.003 kg
Size: 8 × 6 × 1 cm
Nozzle Size: 0.10mm