Key Features
- Higher melt capacity by increasing the surface area of the heating walls
- Flow Rate gains between 25 and65%*
- Machined with ultra-precision
- Brass nozzle with Nickel coated surface
- Follows nozzle standards: Volcano (M6×1×14.5×21)
The Bondtech CHT Coated Brass nozzles are nozzles for High Flow applications. Bondtech CHT® nozzles split the filament into 3 thinner strands allowing to melt the material from within. In doing so, the material melts faster and higher flow rates can be used.
A Nickel coating is applied to the Coated Brass nozzles to provide protection against corrosion, erosion, and abrasion. Nickel coated nozzles have more corrosion resistance and lower coefficient of friction, which allows slicker feeding of material and delays plastic adhesion to the nozzle's surface.
Compatible hotends/blocks:
- E3D Volcano blocks
- Other Volcano type blocks
- Artillery Sidewinder X1 and X2
- Anycubic Vyper
- FLSUN Super Racer
- Artillery Genius Pro
- Anycubic Kobra and Kobra Max
- Lulzbot TAZ MOARstruder
- Others compatible with Volcano…
Compatible materials: PLA, ABS, HIPS, PC, TPU, TPE, Nylon, PETG, ASA, PP, PVA
Item Specifics
1 - CHT Volcano Nozzle
Nozzle Size: 0.4mm
Optimized for 1.75mm filament
Compatible with 2.85mm filament.
Requires 6mm wrench
NOTE: Avoid Cold Bondtech CHT Nozzles Change. Heat up the heat block up tp 280C, or at least above 250C, before removing or tightening any Bondtech CHT nozzle. Use at most 1.5 Nm torque.
*Flow Rate gains may vary. Results depend on the hardware, materials and print settings used.