- An auto leveling sensor for 3D Printer based on open-source.
- Simple, Smart, & Precise with repeatability is around 0.005mm
- Longer Stroke: Up to 1.6mm longer than V2.0
- For Ender 3, Ender 3 Pro, Ender 5, CR -10, CR-10S4/S5, & CR20
- Kit includes V3.1 BLTouch, rack, connector, burner, pinboards, cable ties, screws
BLTouch is an auto leveling sensor for 3D Printers that can precisely measure the tilt of Bed surface. Main functions and controls of BLTouch are same as usual auto bed leveling sensor, consists of RC servo and micro switch. Thus, BLTouch can be applied on almost every board. BLTouch is fulfilled with simple structure and high precision by using progressively designed solenoid and hall sensor. It can be easily applied, since it has a small and simple structure. The BLTouch aims for user convenience and enjoyable printing by adding many smart functions, such as self-test, alarm, alarm release & Touch Switch mode, Blue LED for servo signal indicating and Z-probe(Zmin) Testing. Gathering information & setting up your firmware will be an easy task. For some boards, upgrading to V3.1 can be done without firmware modification.
Self-test: The push pin operate two times in a test when the power is on.
Alarm: The AI will flash the LED indicator if a problem is detected during a self-test or operation.
Wiring defect indicator : Blue and Red LED for indicating wiring defects.
1 - BLTouch V3.1 Sensor
1 - Connector
1 - Rack
1 - Pinboard A
1 - ISP Pinboard
1 - Burner
2 - M3x8 screw
2 - M3x6 screw
5 - cable ties
Firmware: Please move to the Creality Official Website to download.