E3D PT100 Temperature Sensor - 3DMakerWorld, Inc.
E3D PT100 Temperature Sensor - 3DMakerWorld, Inc.

E3D PT100 Temperature Sensor

Regular price $36.89
/
Shipping calculated at checkout.

Key Features:

  • Genuine E3D Parts
  • Replacement PT100 Temperature Sensor
  • Print at higher temperatures with better accuracy
  • 50mm Molex Microfit 3.0 extension cable included
  • Can be used with E3D V6, Chimera, Lite6, and Kraken by using the PT100 Heater Block

PT100's are high temperature, high accuracy temperature sensors that you can now use on your E3D V6 HotEnd instead of a thermistor or thermocouple. PT100's are able to measure higher temperatures than thermistors - up to 400degC, and are more accurate then both thermistors and thermocouples in general. E3D's PT100 sensors are also very easy to handle, being of a metal cartridge type construction that is secured with a set screw, no more fiberglass sleeving or clamping washer. PT100 temperature sensor for E3D cartridge type HeaterBlocks.

The Ultimaker 2 uses PT100 sensors by default, and this sensor allows you to connect your E3D Hotend and Ultimaker electronics with no alteration to the electronics or firmware of the Ultimaker 2.

Item Specifics
1 - PT100 Temperature Sensor
1 - 50mm Extension Cable
Max temperature: 400degC
Cartridge diameter: 3mm
Cartridge length: 15mm
Cable length: 50mm
Cable color: Red
Cable connector: Molex microfit 3.0
Will not fit in the standard E3D Hotends with a standard Heater Block
In most cases, an amplifier board will be required, along with a spare 5V, GND, and a signal pin.
Please be aware that a PT100 is not the same as a thermistor and unless your electronics explicitly supports RTD Sensing devices you will need an amplifier board.

Prop. 65 Warning for California Residents
⚠︎ Warning: This product may contain chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm. www.p65warnings.ca.gov


Recently viewed