Key Features
- Work perfectly with the Adafruit matrices
- Backpacks come with address-selection jumpers so you can connect up to four mini 8x8's
- Built in clock so they multiplex the display
- Use constant-current drivers for ultra-bright, consistent color
- Kit comes with: A fully tested and assembled LED backpack, Ultra-bright 8x8 blue matrix, & 4-pin header
What's better than a single LED? Lots of LEDs! A fun way to make a small display is to use an 8x8 matrix or a 4-digit 7-segment display. Matrices like these are 'multiplexed' - so to control 64 LEDs you need 16 pins. That's a lot of pins, and there are driver chips like the MAX7219 that can control a matrix for you but there's a lot of wiring to set up and they take up a ton of space. We feel your pain! After all, wouldn't it be awesome if you could control a matrix without tons of wiring? That's where these adorable LED matrix backpacks come in. They work perfectly with the matrices we stock and make adding a bright little display trivial.
The matrices use a driver chip that does all the heavy lifting for you: They have a built in clock so they multiplex the display. They use constant-current drivers for ultra-bright, consistent color (the images above are photographed at the dimmest setting to avoid overloading our camera!), 1/16 step display dimming, all via a simple I2C interface. The backpacks come with address-selection jumpers so you can connect up to four mini 8x8's or eight 7-segments (or a combination, such as four mini 8x8's and four 7-segments, etc) on a single I2C bus.
Item Specifics
Backpack Dimensions: 20mm x 28mm x 4mm / 0.8" x 1.1" x 0.2"
Mounting Holes: 12mm x 22mm / 0.5" x 0.9"
This board/chip uses I2C 7-bit address between 0x70-0x73, selectable with jumpers
A bit of soldering is required to attach the matrix onto the backpack but its very easy to do and only takes about 5 minutes.