Adafruit Power Relay FeatherWing
- Turn on and off lamps, fans, solenoids, and other small appliances(up to 250VAC or DC power) using any Feather board
- Compared to Adafruit's smaller Relay FeatherWings, this can handle a beefy 1200 Watts
- Works with all/any of our Feather boards, just wire up the relay control pin to whatever GPIO you like
- Connect a FeatherWing on top of your Feather board with Feather Stacking Headers or Feather Female Headers
A Feather board without ambition is a Feather board without FeatherWings! This is the Power Relay FeatherWing. It gives you power to control, and control over power. Put simply, you can now turn on and off lamps, fans, solenoids, and other small appliances that run on up to 250VAC or DC power using any Feather board. Compared to our smaller Relay FeatherWings, this one can handle a beefy 1200 Watts!
This Wing has a non-latching type relay. You can switch up to 10A of resistive-load current at 120VAC, 5A at 240VAC. With inductive loads, about half that. Check the datasheet for the relay for the exact switching capacity, as it depends on type of load and voltage type and magnitude. This relay is good for handling fairly large devices, computers, TVs, small appliances and more. You can select which pin you want to use for the relay control by soldering closed the jumper on the underside of the Wing.
Please note: If using with high voltages (> 24V) use care and common sense! High voltages require experience, and are only for use by engineers who are comfortable with guidelines and know how to use them safely!
1- Fully assembled and tested PCB
1 - small header you can use to attach to your Feather
Size: 51.0mm x 23.0mm x 20.2mm / 2.0" x 0.9" x 0.8"
Weight: 16.8g / 0.6oz
Some light soldering is required.