- Upgrade Your Prusa Mini or Mini+
- Filament Sensor Compatible
- Hardened Drive Gears
- Adjustable tensioner & Quick release lever
- The hardened steel Dual Drive gears allow you to work with common and abrasive materials.
The Bondtech Internal Filament Sensor Extruder for Prusa Mini may embed the new Prusa filament sensor for Mini or Mini+ on its housing. The extruder may be used with or without the filament sensor.
The thumbscrew tensioner allows the user to fine-tune the pressure exerted by the drive gears onto the filament. This gives you the power to adjust according to your preferences and to optimize for the type of material you are using.
To be able to do material changes in a snap, simply activate the Quick-Release lever to release the tension and pull the material to be changed out of the extruder, keep it activated and insert the new material.
1x Bondtech IFS extruder for Prusa Mini
1x 10076-4 IFS Magnet Holder (PA12)
1x 10076-5 IFS Lever (PA12)
1x 15112 IFS Extruder Plug (HT-PLA)
3x Black nylon zip-ties
4x M3x35 black oxide steel screws
1x M3x12 black oxide steel screw
1x Brass motor gear
1x Thumb Screw assembly
Net weight : 114g
Gearing ratio : 3:1
E-steps value : 415
Extruder Housing: SLS Printed parts in PA12;
Hinge: injection molded.
Note: Prusa Filament Sensor, Filament Sensor Magnets, Filament Sensor Steel Sphere not included
The original Bondtech extruder for Prusa Mini design was proposed to us by Olof Ogland. This new IFS version was developed by Vecko Kojchevski on top of Olof’s work. It’s based on the thoroughly tested BMG (Bondtech Mini Geared) and adjusted to the Prusa Mini original design.